JOHNSTONE SUPPLY

Description:

• Microchannel coil technology Top discharge condenser design with flush mounted grille
• Full perimeter, removable base rails with built-in rigging and access provisions
• Field convertible from side to bottom discharge
• Single piece “Water-Shed” top cover and drip edge
• Protective condenser coil grille
• Rifled tube and enhanced fin coil
• Foil face, cleanable insulation
• Permanently lubricated condenser and evaporator motors
• Multi-speed direct drive high static motor and slide out blower assembly
• Non-corrosive condensate pan internally sloped
• LED diagnostic indicator to verify control board operation
• Induced draft “POST-PURGE” gas control logic
• Blow thru heat exchanger design with aluminized steel tubes
• Internal compressor protection (temperature and pressure)
• Standard cooling operation down to 45°F (low ambient kit to 0°F available)
• Refrigerant system strainer
• Refrigerant access ports externally accessible
• Reliable hot surface ignition
• 208/230V

BtuH Cooling: 24,000; BtuH Heating Input: 70,000; BtuH Heating Output: 56,000; Depth: 49-1/8"; Height: 33-1/2"; Mfg. #: DBYX-F024D070; Min. Circuit Amps: 18.1; Nom. CFM: 800; Nom. Tons: 2; Width: 47-1/4"; Wt. Lbs.: 440;